Setup Instructions for 8ft

Gazebo Assembly Instructions
8 Foot Rectangular Stand RT101 & RT111

Note: The 4-counter model is shown here. If your booth has only 2 counters, please disregard side counter supports andVELCRO® brand fastener sections marked (B).

First-time Assembly:
Allow 30-45 minutes, power screwdriver with Phillips bit required.

• 1) Starting at one end, use rubber hammer to fully insert cross pieces into frame vertical assemblies (keep all snaps facing out, VELCRO® brand fastener pipe on top)
• 2) Insert screws on the underside of the fittings where shown () to secure the cross pieces. Use a power driver.
  GLUING CROSS PIECES VOIDS WARRANTY
• 3) Insert both notched pipes (A), with notch on top
• 4) For easy transport, corner swivels fold in.

Booth Setup:

• 1) Unfold bottom frame into rectangle with snaps facing out
• 2) Assemble valance frame, snap on valance vinyl
• 3) Lift the valance frame, insert into frame sockets
• 4) Snap skirt on, starting at one end
• 5) Clip counter legs to frame. Attach counter support cross braces.
• 6) Align counters over VELCRO® brand fasteners and press down firmly to secure.
• 7) Place optional undercounter shelf on bottom counter leg braces.